Palfinger-crane-manual-error-codes Link Official

Never direct a high-pressure power washer nozzle directly at electronic control boxes, angle sensors, or valve solenoids.

| Category | Typical Prefix | Meaning | | :--- | :--- | :--- | | | E-01 to E-10 | Low battery, alternator issues, bad ground. | | Sensor (Length/Angle) | E-20 to E-39 | Potentiometer out of range, broken wire in boom tip. | | Pressure/Load | E-40 to E-59 | Overload warning, pressure sensor failure, LMI calibration off. | | CAN Bus / Communication | E-70 to E-99 | Display not talking to central module, wiring harness damage. | Palfinger-crane-manual-error-codes

: Often relate to initialization errors or "unknown encoder" faults, typically caused by wiring issues or faulty angle sensors. Never direct a high-pressure power washer nozzle directly

Broken connection to pressure transducer (Piston side/Rod side). 20-U230: Short circuit or faulty pressure transducer U230. Operation & Safety 63: Lever not in neutral position during startup. | | Pressure/Load | E-40 to E-59 |