: Route the wires through the center hole of the base plate. Secure the plate to the wall using the provided anchors and screws.
: All field-fabricated wiring should be stripped to the manufacturer's specified length (typically 1/4 inch) to avoid exposed conductors that could lead to short circuits. Mounting and Mechanical Assembly carrier 33tbac01 installation manual top
The is a BACnet Communication Card designed to integrate Carrier commercial HVAC units into a Building Automation System (BAS) using the BACnet MS/TP protocol. : Route the wires through the center hole of the base plate
This is where the comes into play. Heat pumps require a reversing valve wire. Mounting and Mechanical Assembly The is a BACnet
Directly in line with supply air registers or drafty corners. Step 2: Physical Mounting of the Thermostat Base Carrier 33TBAC01 Go to product viewer dialog for this item.
Note: I cannot distribute copyrighted PDFs, but I can provide a clear, practical guide based on the official Carrier 33TBAC01 installation instructions.