The finished floor must be perfectly level within ±2mm across the entire footprint of the turnstile array.
Measure the gap between the glass leaves (or between the leaf and the receiving cabinet). The gap must be perfectly uniform from top to bottom. gunnebo speedstile fl installation manual
Clean the sensor lenses with a microfiber cloth if calibration errors occur. 7. Troubleshooting Common Installation Errors Probable Cause Wings misaligned when closed Cabinets not level or parallel Re-check floor leveling; adjust internal feet. Tailgating alarm triggers falsely Misaligned IR photocells Clean lenses and adjust sensor alignment via control board. Barriers fail to open on signal Incorrect input polarity Check if reader relay is wired to the correct NO/NC port. Unit remains permanently open Fire alarm loop is open Check fire alarm relay continuity and jumper settings. The finished floor must be perfectly level within