Route the remaining cable through the pivoting dual-track handles on the sides of the upright frames.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. dp dual trac 20 assembly instructions full
Ensure every pulley wheel is seated correctly in its bracket and that the cable sits in the groove of the wheel before tightening the bolt. 2. Parts & Cable Identification If you are missing cables or need to verify sizes, Fitness Repair Parts lists specific cable lengths and types for the Dual Trac 20 , which is vital for re-stringing the machine 3. Expert Assembly Tips Hardware Check: Route the remaining cable through the pivoting dual-track
– This phrase is likely a product category or search filter used on retail or fitness content sites (e.g., machines that include entertainment features like a tablet holder, speakers, or workout programs). It's not part of the assembly guide. If you share with third parties, their policies apply
Secure the assembled uprights (11) to the base, utilizing M10 x 90mm carriage bolts (40), M5 x 19mm screws (50), and nylon locknuts (57).
| Problem | Likely Cause | Solution | | :--- | :--- | :--- | | | Floor not level, or stabilizers not tightened | Adjust the rubber feet on the stabilizers. Tighten all base bolts. | | Cable is too loose / has slack | Cable stretched or not correctly routed | Re‑route the cable (see section 3). If stretched, the cable may need replacement. | | Weight stack sticks or clatters | Guide rods not parallel, or plates misaligned | Loosen the top plate, realign the rods, then re‑tighten. | | Bolts keep loosening | Missing lock washer or thread‑locker | Add a split‑lock washer or apply a drop of medium‑strength thread‑locking fluid (e.g., Loctite 242). | | Pulley squeaks | Dry bearing or debris | Clean the pulley groove. Apply a dry‑lube spray (not grease, which attracts dust). | | Lat bar does not reach | Cable is too short or routed incorrectly | Check that the cable is not wrapped around another part. Re‑route if needed. |