Simrad Rf300 Installation Manual

Before mounting the RF300, carefully plan its placement. The feedback unit must convert the linear motion of the rudder into rotary motion without binding or exceeding its mechanical limits. Location Requirements

If the display shows port when the rudder moves starboard, reverse the wiring connections at the autopilot computer or toggle the "Invert Rudder Feedback" option in your software settings. 🔍 Maintenance and Troubleshooting Routine Maintenance simrad rf300 installation manual

If the autopilot is shaky, the linkage rod might be binding or too loose. Before mounting the RF300, carefully plan its placement

The unit comes with a fixed cable. Avoid cutting it unless necessary, and ensure proper waterproofing if splices are made. Wiring Scheme (Generic Simrad AP): Red: +5V (Reference voltage) Blue/Black: Ground (0V) White/Shield: Signal (Rudder Signal) Wiring Scheme (Generic Simrad AP): Red: +5V (Reference

Note: Do not attempt to remove the transmitter arm from the feedback unit itself, as it is factory-adjusted. 3. Wiring the